DTXtremeIIS trigger / pad problems

[Sal]

Hello all,

I have a DTXtreme IIs kit, two of the pads are no longer working correctly (I don't doubt it's operator error)

1st - the #1 tom lost the Rim triggers, only the main pad works/worked. - I do not remember making any changes prior to this happening except downloading a couple kits off a card.

I moved it to the #4 tom and life went on.

now, the "new" #1 tom(was #4) is having the same issue after working ok for a while.
and on occasion the (main) pad double triggers (tom and tamborine) when struck.

I am at a loss, I went through the book, and fiddled with the settings to try to undue the issues - I know the two toms are differnt part numbers, but....

any ideas, similar problems, suggestions, repair info...???

[WildWes]

Sal,

Have you done a "factory reset" to determine if that will fix the zone issue?

Just remember a "factory reset" will erase all changes to user kits you have saved. WW

[TAKnipe]

Sal, Make sure each pad in the brain has the trigger settings set to tp100. This will probably do the trick and like Wes said try a factory reset. If the problem persist we can try the pads on my xtreme 3. T

[BobbyMck2]

You could make sure the leads are in correctly, it's not a defective lead, or clean the jack with a little switch cleaner

[Sal]

I have cleaned the connections, but not done a factory reset, I will do so asap.
I will also chck to see that the pads are set to tp100 and advise

thanks
Sal

[Sal]

factory reset did nothing to rectify the problems...swapped leads, cleaned leads, still no change...the pads are set to tp1....the problem(s) definitly follow the two "bad" pads as i move them or the leads around..